Pololu Custom Laser Bedienungsanleitung PDF herunterladen (Seite 5)

3. Materials for Laser Cutting

We can laser cut plastics, woods, rubbers, foams, papers, and thin metals as long as they do not contain chlorine.

Depending on the material, there is usually no limit to the thinnest sheet we can cut, and the thickest sheet we can cut

is typically 1" (24 mm). We stock some woods and various plastics including acrylic, ABS, Mylar, Delrin®, PETG,

and styrene, and you are welcome to mail us material or have suppliers ship us material directly. A complete list of

materials is available on the quote request form [http://www.pololu.com/laserquote/new].

Materials we can laser cut

We can cut the following materials. If you do not see your material listed, we would be happy to try cutting it as long

as it does not contain chlorine (please submit a quote request and provide details about your material in the special

instructions section of the quote request form).

• Plastics:

◦ ABS (acrylonitrile butadiene styrene)

◦ Acrylic (also known as Plexiglas, Lucite, PMMA)

◦ Delrin (POM, acetal) – for a supplier, try McMaster-Carr [http://www.mcmaster.com/].

◦ High density polyethylene (HDPE) – melts badly

◦ Kapton tape (Polyimide)

◦ Mylar (polyester)

◦ Nylon – melts badly

◦ PETG (polyethylene terephthalate glycol)

◦ Polyethylene (PE) – melts badly

◦ Polypropylene (PP) – melts somewhat

◦ Styrene

◦ Two-tone acrylic – top color different than core material, usually for custom instrumentation panels,

signs, and plaques.

• Thin metals:

◦ Stainless steel (up to 0.060")

◦ Spring steel (up to 0.060")

• Foam:

◦ Depron foam – often used for RC planes.

◦ EPM

◦ Gator foam – foam core gets burned and eaten away compared to the top and bottom hard shell.

• Other:

◦ Cloths (leather, suede, felt, hemp, cotton)

◦ Magnetic sheets

◦ Papers

◦ Rubbers (only if they do not contain chlorine) – for a supplier, try McMaster-Carr

[http://www.mcmaster.com/]

◦ Teflon (PTFE, Polytetrafluoroethylene) – for a supplier, try McMaster-Carr [http://www.mcmaster.com/].

3. Materials for Laser Cutting Page 5 of 29

1 2 3 4 5 6 7 8 9 10 ... 28 29

Keine Kommentare

Pololu Custom Laser Bedienungsanleitung Seite 5